Desco Benchtop Zero Volt Ionizer, Model : 50670
  • The best balancing ionizer available
  • Offset voltage balance controlled to ±3 Volts typical tested per ANSI/ESD S3.1
  • Fast discharge times and offset voltage well below < +/- 50 volt required limit of ANSI/ESD S20.20
  • Features steady state DC ionization and EMIT's patented (US Patent #4,974,115) Sense Feedback balancing
  • Sealed "Thru-Tunnel" air flow design
  • Communication via RS485 compatible data output with a host computer
  • CSA certified
  • Made in America
  • 5 year limited warranty
  • Low Ozone Emissions – tests well below the OSHA limit of 0.05 ppm ozone
  • RS485 Data Output Port – consult factory for further information
Overview

The Bench Top Zero Volt Ionizer is a compact and lightweight steady state DC auto-balancing bench top ionizer with integrated closed-loop feedback. The unit is normally placed at one end of the workbench or area to be neutralized. It may also be mounted to a wall or shelf. The Ionizer's neutralization discharge time will be best approximately 12" to 48" directly in front of the unit and will increase as the distance from the unit increases.

Ionizers are useful in preventing electrostatic charge generation, ElectroStatic Discharge, ElectroStatic Attraction, as well as preventing equipment latch-up and safety related shock. Per ANSI/ESD S20.20 section 6.2.3.1. Protected Areas Requirement states: "Ionization or other charge mitigating techniques shall be used at the workstation to neutralize electrostatic fields on all process essential insulators if the electrostatic field is considered a threat." Air ionization can neutralize the static charge on insulated and isolated objects by producing separate charges in the molecules of the gases of the surrounding air. When an electrostatic charge is present on objects in the work environment, it will be neutralized by attracting opposite polarity charges from the ionized air. Note that ionization systems should not be used as a primary means of charge control on conductors or people.

Installation:

Place the unit at a desired location where that the airflow will not be restricted. Be sure that the ON/OFF switch located on the rear of the unit is in the OFF position. Plug the power cord into the unit and then into the appropriate AC power source.

Operation:

I. Set the fan speed switch on the rear of the unit to the LOW, MED, or HI position. Higher airflow will result in faster neutralization rates.

II. Position the ionizer so that maximum airflow is directed towards the items or area to be neutralized.

III. Turn the unit ON. When the unit is first turned on, it conducts a self-test. The audible alarm will sound and the LED will cycle through the colors red, yellow, and green. The LED will remain green during normal operation.

© 2014 Pro-Pack Materials. All Rights Reserved | Website designed, developed and hosted by PROFOSOFT.